Tips for Mounting Pressure Transmitter Tubing?

For gas pressure transmitters, the transmitter is mounted above the tapping and the tubing must have a minimum slope of 5% to drain any condensates.

For liquids, if the transmitter must be mounted below the tapping, the tubing must have a minimum slope of 5% to purge any gases.

In the presence of very hot fluid (e.g. steam), the sensor must be protected (add heat sink etc.).

If the sensor is above, a siphon must be installed or a low point must be created to allow condensation > cooling of the fluid in contact with the measuring cell.

Any interest about our pressure transmitters like UPB8 high temperature pressure transmitter, UIB1 digital pressure transmitter etc., please contact Stella Meng.